585,754 active members*
3,785 visitors online*
Register for free
Login

Thread: Using Parentheses....

Results 1 to 2 of 2
  1. 03-30-2008, 05:23 AM #1
    Bluegillman
    Bluegillman is offline Registered
    Join Date
    Mar 2006
    Posts
    85

    Using Parentheses....

    Do anyone know how to do feeds/speeds as in RPM and IPM using the parentheses? There is a teacher who asked if I knew how to use the ( ) and he can make the worlds easier to figure out the feeds and speeds but he never got to that part on it. I have been asking everyone on how it is done and alot do not know how to use the ( ) on the calculator.
    Reply With Quote Reply With Quote
  2. 05-21-2014, 02:40 AM #2
    daveallen Guest

    Re: Using Parentheses....

    For a free trial of The Machinist Black Book email DaVicki-llc@outlook,com and put trial in the subject.
    Speed and Feed calculator for over 3000 materials and handy references for the machinist and programmer.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Brackets vs Parentheses in Macros or Subprograms
    By keystone76 in forum Fadal
    Replies: 5
    Last Post: 02-27-2012, 06:00 PM
  2. 21-T control switching from parentheses to brackets
    By BobM3 in forum Fanuc
    Replies: 3
    Last Post: 07-15-2011, 02:54 PM
  3. edit inside Parentheses
    By GPdriver in forum Fanuc
    Replies: 5
    Last Post: 04-08-2011, 05:18 PM
  4. Parentheses on 16t controller
    By rmailly in forum Fanuc
    Replies: 3
    Last Post: 05-09-2008, 06:25 PM
  5. Using Parentheses....
    By Bluegillman in forum MetalWork Discussion
    Replies: 0
    Last Post: 04-02-2008, 03:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules