not sure if this is a post problem or somthing i can even do but i have mastercam level 3 x2 mill and am writing simple contour tool paths for a
proto trak conversational control (control turns my g-code into event programming when its loaded into the machine) i would like to add the looping into my g-code that mastercam puts out instead of the machinist adding it in later as a new event. i tried using the sub program check in the depth of cut
box but this added the sub program to the begining of the program and proto trak is reading this as drill postion moves,went to change control definiton to sub program after main and found it already was. anyone got any ideas as to how i can do this. normaly only use cam for my large vmc's put had a job that had to run in the proto