[turbinecrazy]

so what did you punch the holes?

[KNIGHTSCHOPPERS]

WOULD YOU PART WITH THE CAD - LOOKING TO CREATE A TURBINE - THIS WILL BE A GOOD START - WILL NEED TO CHANGE SHAFT SIZE ECT...

THANKS

ERIC

CALL OR TEXT

845-406-7831

WOW I was just rying to get things rolling here. Thanks for all the nice comments. I drew the blade profile in cad and then with a 1/8 in. carbide em (used 4 of them) profiled each blade 20 of them taking .015 depth of cut for a total of .400 deep using a manual indexer rotating every 18 degrees. Probably not this one but the next one I build (in the works) which is a little smaller it has a 54 mm dia. turbine wheel where this one is around 66 mm will be going into an RC jet. Here are sompics of the turbine wheel and of a diffuser that I was milling out with my homemade mill.


Greg

[adam777]

nice job. i love all these pictures. thanks for sharing these pictures.all are great models.
Adam smith
[email protected]
Nitrotek.se