No matter what I put in to Ace for the Z offset and max Z pass values, the G code always comes out with a Z offset of 0.09448031 . What have I done wrong?? It had been working fine for years up until now.
No matter what I put in to Ace for the Z offset and max Z pass values, the G code always comes out with a Z offset of 0.09448031 . What have I done wrong?? It had been working fine for years up until now.
Not sure, but make sure the entities in your .dxf file are drawn at Z=0. If they are not drawn at Z=0. the offset from zero appears to get added to the final depth.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)