586,005 active members*
5,321 visitors online*
Register for free
Login

Thread: Getting my THC Min and Max to trip

Results 1 to 2 of 2
  1. 05-29-2008, 02:59 PM #1
    JaiTalkin
    JaiTalkin is offline Registered
    Join Date
    May 2008
    Posts
    3

    Getting my THC Min and Max to trip

    Im trying to test out for any tripping on the THC Min and Max for my Mach 3 Plasma, but it still seems to go over the limit when i jog up and down my z axis.
    I've done everything possible to try to make it reach its limit, but its not working.
    Any suggestions?
    Reply With Quote Reply With Quote
  2. 06-27-2008, 01:34 AM #2
    Torchhead
    Torchhead is offline Gold Member
    Join Date
    Jul 2005
    Posts
    2415
    That's because the THC min and max settings under THC, control limits of the Z ( to prevent a tip crash if the cut hits a hole or runs off the edge for example) When jogging the Z is just a normal axis and the THC parameters do not apply.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Help to identify this pile of junk, another trip to the flea market.
    By Konstantin in forum CNC Machine Related Electronics
    Replies: 0
    Last Post: 02-02-2007, 12:17 AM
  2. VFD fault trip
    By colin1544 in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 09-25-2006, 10:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules