[myhäje]

Greetings fellow machinists,
I work with an old Nakamura-Tome TMC-2 with Fanuc 6T. The machine works flawlessly, but for some reason the tool position is shown incorrectly. The "distance to go" and "machine position" values are valid. I guess this is because of some parameter, but they are long lost and gone... If someone knows which parameters affect the information about tool position, I'd be glad for the help!
Thanks.

[Faraco]

I just posted trying to find information on parameters and looked at everybody else who did as well... No one ever got a reply. I was wondering if you ever figured out the parameters for this machine. I'm looking for axis lubrication

[tano]

I have nakamura tome TMC-20 with fanuc 10TE-F control.
If they are same tell me

[Faraco]

Mine is a Naka Mure TMC 30. Fanuc Controller 0660-11 (PMC: M068-98). I've been trying anyone who might know but, the machine is just too old. It's parameters page look like this:

6901 11011
6902 10100
6903 11110

and so on. Those are just example not actual states or addresses. So I don't even know if I'm in the right area. Usually work on newer Okuma's and Seiki's. But besides that I need to find the code for axis lubrication on and off. Please tell me you can help me out!