I am new to this forum and need help from you guys, please.
I desperatly need machine parameters, because my buffer batterie's wire came loose and now all the info is lost. Please help urgently.The parameters I need is for the TNC 145 controller.
I am new to this forum and need help from you guys, please.
I desperatly need machine parameters, because my buffer batterie's wire came loose and now all the info is lost. Please help urgently.The parameters I need is for the TNC 145 controller.
something very close has been posted on this board before.
I know that some people have asked the same question about the machine parameters, and a couple of guys told them that they have the parameters and will e-mail it to them, but no parameters found on the forum itself. Please, if anyone's got it, please send it to me.
Zorba,have you got an email address?
Mark.
My e-mail address: [email protected]
If you are too lazy to actually search the forums, you will have trouble keeping the machine running
just a start, I have other things to do
http://www.cnczone.com/forums/showth...t=51625&page=2
http://www.cnczone.com/forums/showthread.php?t=33292
Those parameters are for the R2C3 and not Interact. I've got an Interact. And yes, I did search the forums, and I got no parameters for the Interact. Thanks
The only substantive difference between the parameters between the two are approach direction for referencing and then the travel limits in y and maybe x. both sets of parameters are there, on for an interact with a 151, and one for the r2c3, so you have everything you need.