Hi everyone I ran into a problem rigid tapping left hand , I am use to the usual G84 command for right hand tapping but when I try to use M4 /G84 the machine just sits in front of the part and will not do anything , I talked to a program tech were we purchases the machine and he got back to me and said that this could possibly be a Fanuc option , when he told me this I gave him a silence for a minute over the phone and said to him you have to be kidding me! I have tried using the good old G32 I got an Illegal code alarm I tried G74 got an invalid G code alarm I tried the M72/G84 combo with no luck. this is a 21i controller. And I fear this is possibly a machine builder problem. which has me up against a wall the machine is out of warranty , ha ha sucks to be me! Is left hand rigid tapping really an option? or am I getting hood winked any help I would be grateful.