We have a Miyano BNC-34T with a Fanuc OT control. Last week I lost my RS232 settings used to send and receive programs to the machine. I looked in the manual and found the baud rate, stop bit, and parity settings. I cannot find the setting for the flow control. Does anybody have this information that I could use and check against what I have set is correct? I have the cable from the machine connected to the COM 1 port.
Thank you.
Thread: FANUC OT - MIYANO
Results 1 to 2 of 2
-
06-24-2008, 06:59 PM #1
Registered
- Join Date
- Mar 2008
- Posts
- 1
FANUC OT - MIYANO
-
01-20-2012, 05:38 AM #2
Registered
- Join Date
- Aug 2008
- Posts
- 15
Dear sir
i have a miyano ANC-45S i need the 900 series parameter for this machine we lost the memory , can you send me the parameter 900 series from your machine at my email id
[email protected] our control is fanuc OTT( double turret and head machine we have)
Reply With QuoteSimilar Threads
-
Miyano tooling
By cmincgary in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 03-29-2008, 07:17 PM -
Miyano Tooling
By cmincgary in forum MetalWork DiscussionReplies: 0Last Post: 03-27-2008, 11:55 PM -
Miyano cnc
By gashbourne in forum FanucReplies: 3Last Post: 02-05-2007, 10:58 PM -
is a miyano mtp-3 non existant ?
By dt38k in forum CNC ToolingReplies: 0Last Post: 12-21-2006, 03:29 AM -
Miyano BND-34S Programming Help
By JerryH in forum G-Code ProgramingReplies: 1Last Post: 10-10-2005, 02:11 AM
Posting Permissions
