I want to print on a hard piece of plastic, approximately 4" x 4" square. The material is also approximately 1/4" thick. Does anyone think I could modify an old inkjet printer to feed this through? The material obviously will not flex through the rollers as is but maybe if I remove enough of the case to just slide it in through the rear?....
I have both an old Canon 1000 & a Canon 3000 to disassemble...
Has anyone experimented on something like this? I though I remember reading about someone who did this to print directly onto CD's but can not find it anymore.
or does anyone know where I should be looking?
Thanks
jeff