[famwhaiyun]

I HAVE THE SAME PROBLEM IN ONE LAHTE NAKAMURA-TOME-20II.
MY CONTROL IS FANUC 18TA.
I HAVE OTHER MANUALS AND PARAMETER OF THIS MACHINE.
INCLUDE SPECIAL PARAMETER.
IF SOMEBODY THIS INTERESTED IN THIS PARAMETER I CAN TO SHARE THIS INFORMATION.
THANK YOU FOR ANY INFORMATION THAT HELPS ME TO LEAVE TO THIS PROBLEM.

THANK YOU

ROMMEL ROJAS

Hi Rommel,

I have exactly the same machine with you, tmc 20 II. Would you mind share the parameters and the ladder diagram?

Thanks. You can email me.

Rgds,
Fam

[email protected]

[Richyperu77]

I HAVE THE SAME PROBLEM IN ONE LAHTE NAKAMURA-TOME-20II.
MY CONTROL IS FANUC 18TA.
I HAVE OTHER MANUALS AND PARAMETER OF THIS MACHINE.
INCLUDE SPECIAL PARAMETER.
IF SOMEBODY THIS INTERESTED IN THIS PARAMETER I CAN TO SHARE THIS INFORMATION.
THANK YOU FOR ANY INFORMATION THAT HELPS ME TO LEAVE TO THIS PROBLEM.

THANK YOU

ROMMEL ROJAS

Querido Rommel

Tengo el mismo problema en un torno. Me dicen que la tarjeta MAIN esta dañada. Pero quiero saber si resolviste el problema con tu maquina y como fue la solucion?? Me puedes ayudar??

[Nperez40]

Greetings.
I am repairing a machine with Fanuc 18MA control, I feel that I am very close to solving all these problems that this machine has, but at this moment I am struggling with my A16B-2201-0080 card, when I try to turn on the machine three light up red bulbs as in the picture, unfortunately I don't have the manual.
Can somebody help me. with documentation or tell me where the problem is?