584,837 active members*
4,895 visitors online*
Register for free
Login
Results 1 to 3 of 3
  1. #1
    Join Date
    May 2007
    Posts
    155

    Haas probing Questions

    When you Probe a vise corner in VQC probing

    ands its finshed and moves the probe to the corner ..

    Go into offets and look @ G54 why do the numbers change on x and y

    if you press part Zero set .. shouldnt they stay the same ?

    Thanks for the help ...

  2. #2
    Join Date
    Jun 2006
    Posts
    29
    It moves to a safe position near the corner....not to the corner. If it were actually at the corner, your 6mm ruby ball would be touching the vice by 3mm. The reason it changes when you hit part zero set is because you have just designated that safe position as G54 rather than the actual vice corner.

    I bet that makes sense, huh? Good luck.

  3. #3
    Join Date
    Jul 2005
    Posts
    340
    it moves to the position where you started , just zero your operator positions and run the cycle it should be the same , have checked this in probbing a bore.

Similar Threads

  1. 5 Axis Haas questions
    By PBMW in forum Haas Mills
    Replies: 16
    Last Post: 03-04-2013, 10:42 PM
  2. 93 Haas VF2 Homing Questions
    By Rcky123 in forum Haas Mills
    Replies: 2
    Last Post: 10-23-2007, 02:14 PM
  3. Probing and g10 questions matrix control
    By Liontastic in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 10-04-2007, 09:01 PM
  4. Haas Probing
    By binzer in forum Haas Mills
    Replies: 3
    Last Post: 09-26-2007, 03:52 PM
  5. Haas Lathe Questions - Lots
    By 1ctoolfool in forum Haas Mills
    Replies: 6
    Last Post: 08-14-2006, 12:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •