[inflateable]

Hi all,
I'm starting up another post processor for a lathe, which uses G76 to thread turn.

One of the parameters in the cycle is 'F' for the thread lead. Edgecam has a box for it in the dialogue, (pitchxstarts) in thread turning but I can't find a corresponding token in the code wizard.

Anyone know which token I need to use to output the contents of that box? (And why can't edgecam use the SAME NAMES across code wizard and it's dialogue boxes, it drives me loopy..)

Thanks!

[koppis]

Try PITCH without #. Working for me.

[inflateable]

Thanks Koppis, but through trial and error I've found that dialogue box maps to KPITCH

which doesn't seem right...