Everyone,
I must add that experience is the best way. I also must add on BobCAD's behalf that their manual shows in great detail how to get from drawing to g-code, well done BobCAD!!! Scripting is a very advanced option and I must admit a very nice option indeed, I use it all the time to create my own drawing and g-code programming facilities and I have found that if you know the fundamentals of basic programming and how scripting works, then most of the information you need to have success is in the BobCAD Manual. I must ask this question, when you buy a car you are given a manual that explains where all of the buttons are and what they do but author of the manual will expect that you at least know how to drive the car.
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)