[andre-dolphin]

We have created a new website at

http://www.dolphin-online.net

It contains a host of new tutorial videos etc, we will be adding more as and when we can.

There is also a page concerning on-line training courses that we will be setting up, send any commnets to [email protected]

Many thanks
Andre

[Dolphin USA]

We will periodically be adding new videos as we create them.
If anyone has any ideas of something they would like too see, feel free to let one of us know. This has been a tremendous help to many already.

[harley4ever]

these videos are very nice will more be added?

[Dolphin USA]

Hi harley,

Yes the site is still relatively new. As we create more videos, they will be added to the site. We plan to eventually have a video or part that pretty much covers every aspect.

Hope this helps!

[jmerson]

How about a video on how to make contours when there are gaps in the lines. I made or am trying to make an air cleaner for a 4 carb. engine. I can't buy anything to fit so decided to make one. I'm trying to put a circle or arc on either end of a box. Actually I made a box and then did a fillet on the corners with a radius the same as the box. For some reason there are small gaps where the radius meets the box and when I tried to do a contour the gaps were too big. It would be nice to know how to make a line longer or smooth out an arc or even draw an arc free hand. There probably is but I don't know how to find it.
Thanks,
Jim