using Biesseworks on a Rover B 7.40
I would like to speed up the program work time,
EXAMPLE:
Simply, if you run a bit down a 10ft board using 3 passes, it starts at one end rips down to the other end, lifts up, comes all the way back to the start point, lowers for pass #2, rips back down to the end, and repeats(pass#3).
Is there a way for it to run the first pass lower at the end and come back instead of going always from the start point.
it seems like just a time waste when we all know time=money,money money
thanks.