585,692 active members*
4,902 visitors online*
Register for free
Login

Thread: Looking for Logosol - FlashCut Servo Drive

Results 1 to 2 of 2
  1. 08-20-2008, 02:33 PM #1
    ponthieux
    ponthieux is offline Registered
    Join Date
    Oct 2007
    Posts
    3

    Looking for Logosol - FlashCut Servo Drive

    I am adding a rotary to my FlashCut system. I am needing a Logosol drive # LS182. I read of a lot of people that changed from FlashCut to Mach3. I hope that someone may have one they are not using that they would sell. Thanks,
    Mike
    Attached Thumbnails Attached Thumbnails Logosol---FlashCut-Servo-Dr.jpg  
    Reply With Quote Reply With Quote
  2. 01-01-2021, 05:04 AM #2
    journyman26
    journyman26 is offline
    Join Date
    Jan 2021
    Posts
    3

    Re: Looking for Logosol - FlashCut Servo Drive

    I'm not sure how old this post is but I have two of the 182-1210 and one 182D-1210 that I am not using at the moment. I am trying to figure out if I can plug my step and direction outputs from my smooth stepper into my flash cut servo driver box bypassing the signal generator in order to run mach3.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. CNC servo controller kit (FlashCut) for Sherline, Taig, Ma
    By art4x4 in forum Benchtop Machines
    Replies: 0
    Last Post: 02-25-2012, 10:19 PM
  2. Very short cables to Flashcut Servo motors
    By DonFrambach in forum FlashCut CNC
    Replies: 2
    Last Post: 03-10-2007, 07:16 AM
  3. Short Cables on Flashcut Servo Motors
    By DonFrambach in forum Benchtop Machines
    Replies: 1
    Last Post: 03-06-2007, 06:15 AM
  4. Getting ready to buy a Flashcut 4400V Servo
    By mts in forum FlashCut CNC
    Replies: 3
    Last Post: 03-11-2004, 07:59 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules