We have casting parts of thin wall and we are getting ovality of above 30 microns for 138 bore
Results 1 to 2 of 2
-
12-08-2019, 07:02 PM #1
- Join Date
- Dec 2019
- Posts
- 1
Getting ovality above 30 micron for 138 did bore
-
12-08-2019, 07:32 PM #2
Member
- Join Date
- May 2016
- Posts
- 471
Re: Getting ovality above 30 micron for 138 did bore
Yes and I get a stomach ache after eating too many pancakes!
Originally Posted by sagar1996
This is a juvenile post.
What do you need?
What equipment are you using? Mill? Lathe? Dremel?
What control?
What are the cutting conditions?
What is the setup like?
Cutter used? Depths? Feeds and speeds?
Castings made of what material?
Pictures?
Get it?
Without further information, the only broad fixes I can come up with are slow your feed. Check squareness of machine. Squareness error causes ovality at 45 degrees to the axis. Some squareness can be fixed by proper machine leveling.
Reply With QuoteSimilar Threads
-
Horizontal Machining Center - Ovality in Job
By M.RISHIKESH in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 08-18-2015, 07:06 PM -
Ovality achieved By electrode
By Ashish B in forum EDM Discussion General TopicsReplies: 0Last Post: 02-28-2011, 08:04 AM -
Reamed Hole ovality
By Ramu in forum CNC Machining CentersReplies: 1Last Post: 04-04-2010, 03:07 PM -
Ovality issues for aluminium parts
By Viru in forum MetalWork DiscussionReplies: 7Last Post: 04-04-2007, 04:40 PM
Tags for this Thread
Posting Permissions
