[davide.castro]

hello,

I have a Fanuc OM Model C.
The program 9000 is active to tool change, if i made a program like
T1 M06;
M30;
In aut works well.
But in MDI mode i put T1»»input»»M06»»input»»start it doesn't work.
I can't in MDI insert in same line T1 M06 (the insert in not possible)
And always M06 is made before T1 and only change in table "M03" to M06.
Can help me.

Thanks

Castro

[dcoupar]

Try typing the following:

T1M6; then press the INSERT key. (; = EOB)

[Namnp2007]

Oh, maybe you can try M06 ( input) then T1( input) followed Start

[davide.castro]

In MDI mode I can't put in same line T1M06, but in edit mode i cn put in the same line.

Thanks
Castro

[Namnp2007]

You may need to input M06 fist.

[dcoupar]

How about T01 INSERT M06 INSERT EOB INSERT?

[Namnp2007]

In case of my OM machine, if I put T01 first then the machine can't run correctly, it's easy to fix if I put M06 first( maybe pushed Cycle Start) then T01, the machine runs correctly that way.

[davide.castro]

How about T01 INSERT M06 INSERT EOB INSERT..
The insert doesn't work in MDI, I think the problem is in parameters.

Castro

[Namnp2007]

@davide.castro
Did you have OM parameter manual? If not, pls. sent me your E-mail address, I'll sent you OM parameter manual and OM parameter, witch I wrote from normanly run machine.

[screws]

i have same problem. way i do it is like this t01 insert .(cycle start)m06 insert (cycle start) it takes time but how often you have to do it. i don't mind.

[davide.castro]

My email is [email protected]

Thanks

Castro