Hello,
I'm having trouble getting the required 32 finish on the inside corners of a
1.365-1.685 face groove with a depth of Z-.104.
The material is 304L stainless.
Using a .118 wide Iscar face groover (.010 radius corners).to rough and a . 079 face groover (.005 radius corners)
(these are my only choices).
The finisher is doing great on the sides and floor of groove but I'm getting a
slight chatter on inside corners.
Working with .0005 to .001 ipr feed.
300-350 sfm. I tried up to 400 sfm but the problem worsened.
I've used several tool paths but still have'nt found the right combo.
Any suggestions are much appreciated.
By the way - I am glad I found this site, it looks great.
Thanks again!