Gents,
I have a custom G code set to call program 9018 for setting my tool height and diameter data. In program 9018 I have a subprogram call to call program 7000 were all my speeds and feeds are set for each tool. In this program I have a custom G code to call 9014 so it bounces through 7000 until it matchs to tool speed and feed to the tool in the spindle.
When it hits the G-code in 7000 it alarms out with PS010 IMPROPER G-CODE. Any of these two G-codes when called in MDI work properly. Is the problem that I am calling a custom within a custom?? Or is this an option because the alarm description also reads "Also occurs if a G-code corresponding to a non-additional option was specified"?
I am running a Fanuc 15MF
Stevo