[Playback]

Hi, my boss have buy a old cnc lathe Baxter Furure... and before the shipping the machine work well. My problem is when I power ON the machine the 2 axe LED on front pannel blink one after the other and the axe dont work. The cpu work good, I have acces to parameter menu and offset, program.... I have check all fuse and check all plug and all card for good connection and the front door switch and the only one is bypasse. I start the cpu with e-stop and I have the ready LED ON on both axe drive and when I remove the e-stop I have the ready and power ready LED ON on both drive. And the air is plug. I dont know if a sequence of button is need to start or someting to do to start. The setector at HOME and I try X and Y joystick to homing axe and noting work I always have this 2 LED blinking.

If somebody have ideal I am happy to try it.

Thanks!

Playback




2 AXE LED


2 LED blink on after the other.


Axe drive LED ready ON with e-stop.


Axe drive LED ready and power ready ON with out e-stop.

[Al_The_Man]

It appears you have a Not Ready State, this is usually the auxiliaries have to be on, is there another control On PB? If the machine has hydraulics, the hydraulic pump should be on.
I would guess the MTB set the two LED's up to flash indicating the machine needs to be homed.
Al.

[Playback]

Hi Al_The_Man, thanks for the reply. For your question, no the axe don't move. No hydrilic, only air for chuck and close or open i am not able to homeing axe. I dont know if is possible to loss a parameter? I do not have check that.

Thanks!

Playback