584,800 active members*
4,693 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Oct 2008
    Posts
    100

    VB System Failure??

    So I bought a new machine because my laptop was just not powerfull enough.. All set up, ready to go. Loaded mach.. and fired it all up and get nothing.

    It says VB System failure at the bottom field...

    Anyone?

  2. #2
    Join Date
    Mar 2003
    Posts
    35538
    Did you reboot after installing, but before starting it the first time? If not, try uninstalling, then reboot, then re-install, then reboot again before starting Mach3.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

Similar Threads

  1. Dynapath System 10 Monitor Failure
    By nybuxt in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 03-01-2008, 09:07 AM
  2. bridgport vmc hdd failure
    By jke6113 in forum Bridgeport / Hardinge Mills
    Replies: 4
    Last Post: 01-15-2008, 11:34 PM
  3. x axis failure
    By Legion99999 in forum Syil Products
    Replies: 1
    Last Post: 10-26-2007, 08:16 AM
  4. Spindle failure
    By mechanicer in forum DIY CNC Router Table Machines
    Replies: 9
    Last Post: 11-01-2005, 12:11 AM
  5. Bearing Failure
    By Mr.Chips in forum DIY CNC Router Table Machines
    Replies: 5
    Last Post: 11-15-2003, 05:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •