Re: AS3000 3D Level 5 CAD/CAM Software
Avery,
We read this message after answering your last message the other Thread.
Okay, that a good basis. We will need you to contact us , to get more detail on these machines. We can certainly provide the Hurco post processor as well as the custom 5 spindle drilling machine. We will need to configure the post for the custom 5 spindle machine , not sure on the Hurco yet.
In the last post, we mentioned that Level-1 has limitations. So we also have to look at your IGES files to see if you need to upgrade.
We see the both Mike and Jim spoke to one of the other techs here this morning. Avery, get with Mike and Jim then contact us below:
Tech Support
CamSoft Corp.
[email protected]
PH 951-674-8100
Fax 951-674-3110
CNC Controller, PC Based CNC Controls
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)