G'Day everyone,
I own a Multicam 3 axis router table (stepper). It runs a very old (98') version of toolpath. I am looking into possible upgrade to something more recent since the old version will only operate on windows 98 second edition. I contacted Multicam and was told their later software wouldn't run that machine.

So, after doing some searching I noted that Mach3 can be used to run a router table with up to 6 axis. What do I need to do to convert my machine to run on Mach3? Do I need a whole new driver card for the machine? The old card that talks to the machine plugs into the very early slots (ISA) before PCI. If somebody could point me in the right direction that would be great.

Regards,
Chris