What would be a good starting point for say a Cutmaster 52 with a 30amp tip cutting 20 gauge mild steel.
Anyone know of a chart ?
Want to have it set close for ATHC to work well.
How about IPM recommendation?
What would be a good starting point for say a Cutmaster 52 with a 30amp tip cutting 20 gauge mild steel.
Anyone know of a chart ?
Want to have it set close for ATHC to work well.
How about IPM recommendation?
Anyone know a good rule of thumb for settings?
I ruined a 60 amp tip on one cutout and I'm sure I didn't have the right tip voltage setting for my tip OR material because the torch didn't seem to keep proper distance from metal. Any help?
bueller, anyone?
KTM abuser
program to cut a 10"+ line at rec. speed set torch rec. height off steel thc off and cut, watch tip volts. This will give a baseline.
My hypertherm 1000: 60 amp machine
40a tip 148 volts 22G steel 325 ipm
fine cut 40a tip 78 volts 20G steel 120 ipm
I use a 20 Amp drag tip with a 20 Amp setting. Drag the tip right on the metal for thin gauge stock. Works for me.
Up to what thickness? 1/16"? What IPM for 20amp on different gauges?