Greetings,
I have little problem with Miyano/Mectron MTV-310 milling machine with Yaskawa Yasnac J100M (12100-38) drive system and ATCs SGDB-10ANY11 Sigma I servopack, the servopack is changed new and configurated right. Servomotor has 12 bit Absolute encoder and brake (motor type is SGMP-08AWMN31). The milling machine is new for us, and it wasn't newer working for us.
When power is connected first time on.
NC panel Alarms are:
2011 (S-OT1), 2012 (S-OT1), (x- and y -axis is in over travel)
2180 Sequence 1 --> User alarm (A35 Magazine index alarm)
2190 Machine unready
3000 Servopack power off
3002 Emergency Stop ( because of over travel)
then when trying to run machine (press release machine end button) and rst and then power on again. Main contactor is operating and release after 2 sec. And same alarms is in alarm table plus 3240 serquence 2 alarm (A37 magazine inverter alarm). The servopack SGDB-10ANY11 alarm (red led) lit all the time and the this servopack contactor will not connect power (all other phases) the servopack anytime. Absolute encoder is resetted by wire, and digital operator will not give any alarms for atc(magazine) (all is a.99).