Hi everyone,
new to the forum and cnc in general, just acquired an adept mk11 cim centre. -www.appliedresolution.com.au. It looks as though it is complete and comes with the interface cable and original software. My question though is does anyone have any experience with this machine and does it interface to the parallel port of a PC or does it need an add on card, as if it does none was supplied?
The software that comes with the machine is very basic and windows orientated and I was wondering if anybody is using the EMC2 project to drive it?

I'm not after hand-holding but it would be nice to chat with people who have gone down this route and hear of their experiences with this little beastie.

Cheers,
Rob