[visky]

I am sending messagges to emc users list but i never get any reply and i don't see messege on the list.

Is this list working????

If anyone here can help me...

i have to made absolute analog output signal 0 - 10 Volt.

loadrt scale count=1
addf scale.0 servo-thread
setp scale.0.gain -0.004
net spindle-speed-scale motion.spindle-speed-out => scale.0.in
net spindle-speed-DAC scale.0.out => m5i20.0.dac-03-output

This is working but only with M3 code. When i use M4 S**** i get negative voltage output and spindle do not work.

Thanks

[Bubba]

yep, its working. I have gotten 7 messages so far today and I get several each day.

Sorry I can't help you with your problem as I am a complete nooby at emc.

[samco]

If I am understanding what you want.. Could you send the motion.spindle-speed-out thru abs? (take the absolute value of it)

http://www.linuxcnc.org/docs/2.2/htm...an9/abs.9.html

then it would always be positive..

[cadmonkey]

did you subscribe to the list through sourceforge or just start sending messages to it?