[sswitaj]

Hi guys;

Sadly, this is only a small job, but maybe someone has a couple of hours open that they'd like to fill.

This is a mounting bracket for circuit cards, .25 x .25 x 1.65, with 4 threaded 4-40 holes. Tolerances are nominal.

Material is not critical, aluminum or steel, any alloy.

Break all edges and flush chips so that part does not any shed any latent tiny chips onto circuit boards.

Typical clean mill finish without any dramatic tool marks is fine.

I need 72 pieces, in 2 weeks or less.

Drawing is attached.

You can contact me directly at sswitaj (at) aol (dot) com

- Steve

[levelzero]

Relatively straight forward part, the only real problem I see is that if the end holes break through the traverse holes it would compromise the threads slightly.

Would standard 0.25" stock be fine? This would save a fair bit of machining.

[67chevym]

hi,
please send a print to [email protected]
Thanks

[besc]

Sent PM. Mike.

[Drake75]

Pleas send me a print along with an exact due date. [email protected]

thanks.

[jetpig1]

Bidding closed ?

[metlshpr]

If the job is still open, I would like to quote it. Is material cost to be in the quote? Thanks [email protected]

[MattRMD]

Still open? I would like to bid,
Thanks

[joe sampson]

sent you a quote to your aol e-mail,thanks Joe @ tuson enterprises