585,741 active members*
4,992 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking > MetalWork Discussion > Milling Deep, Thin Slots

Thread: Milling Deep, Thin Slots

Results 1 to 2 of 2
  1. 01-24-2009, 01:42 AM #1
    divinecnc
    divinecnc is offline Registered
    Join Date
    Jan 2009
    Posts
    1

    Milling Deep, Thin Slots

    I am trying to mill a slot into 410 stainless. The depth of the slot is ½ inch deep. The overall depth is 3.400 deep. Slot width is .293 wide. This slot does not go through the part. Does anyone have any suggestions or recommendations on how to do this?

    Thanks!
    Reply With Quote Reply With Quote
  2. 01-24-2009, 05:31 AM #2
    Konrad
    Konrad is offline Registered
    Join Date
    Oct 2003
    Posts
    192
    .293"... is fairly wide, staggered tooth milling cutters are used for something like this.

    Konrad
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. milling deep thin slot
    By dlenardu in forum MetalWork Discussion
    Replies: 7
    Last Post: 01-26-2009, 03:23 AM
  2. milling thin wall brass tubing
    By jackie_burton@m in forum Material Machining Solutions
    Replies: 11
    Last Post: 09-29-2008, 09:46 PM
  3. Need some small milling slots done
    By Jeff Wohlt in forum Hobby Discussion
    Replies: 0
    Last Post: 06-19-2008, 07:34 PM
  4. Milling T-slots in cast tool plate
    By LeeWay in forum MetalWork Discussion
    Replies: 4
    Last Post: 12-17-2007, 07:52 PM
  5. milling deep pocket
    By barnesy in forum MetalWork Discussion
    Replies: 8
    Last Post: 09-16-2006, 11:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules