[junaid.wahid]

hi, All
my mill km3 have some problem on manual mod all axes is moving very slowly and when i send NC data from my PC recive correctly but work slowly as manual mod untill feed rate is 1000 and also feed rate nob is not geting slow or fast it is not working please help me

[Buddy1]

What control do you have? B, BX or Ultimax?

Buddy
www.amtsinc.com

[junaid.wahid]

first thanks a lot,

i have km3 with ultimax. problem is that my all axes are running very slow on both mod (manual,Auto) i checked that upper connector of "fault logic board" was loose i pushed it machine start again now machine is not power up and dual axes board have two green LED "DS1 and DS2" after some time DS1 LED get off but when i pulled out the upper connector of F.L.Brd so machine power up normaly all axes move but very slow.
hope you will help.

[rasheed]

hi, All
my mill km3 have some problem on manual mod all axes is moving very slowly and when i send NC data from my PC recive correctly but work slowly as manual mod untill feed rate is 1000 and also feed rate nob is not geting slow or fast it is not working please help me

if u from pakistan u call me i will help u 03009211929