Hi all, We have a KIA va-50 cnc mill with a fanuc 10 control. Lately we have been getting this alarm on start-up in the morning. The table is roughly centered in it's travel, so it's no where near the limit switches. We normally can't reset the alarm for what ever reason. If we let it sit for a while, say an hour, sometimes then we can reset it. We've been leaving the control on to avoid the alarm, but yesterday we had a power surge that set off another alarm and we couldn't clear it, so we had to power down the machine, and now we have the overtravel issue again, but now it won't clear up. We are trying to convince the boss to trash it, but we could still use it very much in the short term.
Any help or ideas would be much appreciated.
Thanks,
Chappyd