:drowning:Guys,
I'm drowning here, w/ a stupid problem I can't figure out. NX6.1.something. I change my customer defaults for drafting, close NX reopen, check the defaults (yes they are changed), go into drafting & it is still using the stock settings. Look at the preferences & they are set to stock. I thought customer defaults would override the preferences. Where am I going wrong?
Thanks,
Jer
Thread: customer defaults
Results 1 to 2 of 2
-
02-05-2009, 01:55 AM #1
Registered
- Join Date
- Mar 2008
- Posts
- 10
customer defaults
-
02-05-2009, 02:01 PM #2
Registered
- Join Date
- Apr 2007
- Posts
- 12
You only use the new customer defaults when you start a new part. If you want to use the new settings, for instance annotation: go to preferences>annotation and press "load all defaults". It is not possible to read in all customer defaults whith one command.
Reply With QuoteSimilar Threads
-
Preadator 7.0 defaults
By orizaba in forum BobCad-CamReplies: 2Last Post: 06-06-2008, 04:38 PM -
Looking for a new customer
By Billmac in forum Employment OpportunityReplies: 1Last Post: 01-02-2008, 04:33 AM -
Mastercam x2; Help! Coolant always defaults to off.
By L.Kiefer in forum MastercamReplies: 15Last Post: 12-27-2007, 09:02 PM -
Customer Visits
By cdlenterprises in forum Community Club HouseReplies: 6Last Post: 03-24-2007, 02:31 AM -
Rhino_Tools_Options Defaults?
By robinsoncr in forum Rhino 3DReplies: 2Last Post: 06-12-2006, 05:07 PM
Posting Permissions
