I have a Fagor 8025TG control driving an Accuslide CNC. I'm wondering if there are any users out there that know how to adjust the table alignment. I'm getting a small amount of run out on longer parts that I would like to correct. I have a job that needs to have 1.5" of threads coming up so I need to get it dead nuts on.
I've never had the table apart so I don't know it there are adjustable gibs on the rails or the table just needs to be shimmed. Also, is there a specific way to go about disassembling the table or just start removing screws? There are no grease fitting anywhere that I have been able to find so I have just been spraying oil underneath to lubricate. Anyone have a better idea on lubing?