585,668 active members*
4,353 visitors online*
Register for free
Login

Thread: Ezpath

Results 1 to 2 of 2
  1. 02-17-2009, 01:58 AM #1
    camtd
    camtd is offline Registered
    Join Date
    Nov 2005
    Posts
    244

    Ezpath

    Is anybody using Featurecam to program and post to a Bridgeport Ezpath lathe?

    If so is it true you can post either conversational or gcode?

    Thank You
    Reply With Quote Reply With Quote
  2. 02-17-2009, 07:04 AM #2
    duluthboat
    duluthboat is offline Registered
    Join Date
    Sep 2003
    Posts
    363
    A few years back I used FeatureTurn to program an EZPath lathe. The control we had would read both G-code and conversation. I always used the conversation post. It worked just fine after a few minor changes to the post processer.
    Gary
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Ezpath Data Inquieytigation
    By NC Cams in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 01-18-2009, 07:12 AM
  2. EZPath II CSS problem
    By Gncc50 in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 11-22-2008, 07:43 PM
  3. ezpath fault
    By evo123 in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 06-30-2008, 09:42 PM
  4. Ezpath Iiis Error Msg
    By Zombiestomp in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 10-27-2007, 03:08 PM
  5. Bridgeport EZPath help needed!
    By VSMIGuy in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 01-09-2007, 12:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules