585,760 active members*
4,061 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Cincinnati CNC > It’s been a while still initializing found this though

Thread: It’s been a while still initializing found this though

Results 1 to 4 of 4
  1. 06-23-2022, 03:13 AM #1
    tom o
    tom o is offline Registered
    Join Date
    Nov 2012
    Posts
    145

    It’s been a while still initializing found this though

    The Avenger 250T sill isn’t fixed but I found this in the manual (last page)
    Does anyone know about this?
    Attached Thumbnails Attached Thumbnails AD8B679F-867D-4FC2-A2F7-D5DC983A5C21.jpg  
    Reply With Quote Reply With Quote
  2. 06-28-2022, 04:38 PM #2
    meckardt55
    meckardt55 is offline Registered
    Join Date
    Dec 2006
    Posts
    584

    Re: It’s been a while still initializing found this though

    I could not open your attachment.

    MIKE CNC Machine Services INC | Cincinnati Milacron MachinesCNC Machine Services
    Reply With Quote Reply With Quote
  3. 06-28-2022, 11:51 PM #3
    tom o
    tom o is offline Registered
    Join Date
    Nov 2012
    Posts
    145

    Re: It’s been a while still initializing found this though

    Strange it’s only a picture of the page
    Reply With Quote Reply With Quote
  4. 06-29-2022, 08:38 PM #4
    gwood
    gwood is offline Member
    Join Date
    Mar 2008
    Posts
    285

    Re: It’s been a while still initializing found this though

    The page you show is the Initialization of the Spindle Drive Parameters; prior to entering them from a Factory Set-up Sheet. Contact Fives-MSI 1-859-534-4750 if you need more.
    If the control screen shows "Initialization Required" that is due to a power failure, or reloading of software and totally different.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mazatrol T32 initializing
    By terra103 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 16
    Last Post: 07-13-2023, 06:33 PM
  2. HELP! PlasmaCAM Doesn't Finish Initializing
    By humbyrds777 in forum PlasmaCam
    Replies: 2
    Last Post: 06-13-2018, 02:32 AM
  3. Z axis trouble while initializing?
    By Bradsky in forum PlasmaCam
    Replies: 1
    Last Post: 12-20-2011, 07:01 PM
  4. Battery change and initializing position _ NL series
    By aidenkim in forum Mori Seiki lathes
    Replies: 2
    Last Post: 08-26-2011, 02:28 PM
  5. Re-initializing Controller Software
    By Geof in forum Haas Mills
    Replies: 2
    Last Post: 03-18-2007, 06:54 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules