584,863 active members*
4,802 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > Fanuc > 0-MD Machine loses absolute coord with reset
Results 1 to 7 of 7
  1. #1
    Join Date
    Sep 2008
    Posts
    12

    0-MD Machine loses absolute coord with reset

    I'm operating an EAGLE 1000 with a fanuc 0-md control.
    Every time the reset button is pressed the absolute coordinate values change losing the g54 coord reference. The only way to bring the right coords back is to reference the axis (xyz home).

    any help please

  2. #2
    Hi,

    Please check that the Manual Absolute switch is on, G127.2 is showing 1.

    Kind Regards

    Frank Moss

    Fanuc Repair

  3. #3
    Join Date
    Sep 2008
    Posts
    12
    Hi Frank

    I much appreciate your reply

    Ive checked the parameters and the bit is set at 1
    G0127 00000100

    Is this right?

    Ian

  4. #4
    It is the diagnostic no (DGN) that you check press the param/dgn button twice to display dgn screen, then page down to g127.

    Regards
    Frank

  5. #5
    Join Date
    Sep 2008
    Posts
    12
    I have the right diagnostic page g127 00000100

    ian

  6. #6
    Join Date
    Oct 2008
    Posts
    106
    DGN G127 bit 2 = 1 mean Absolute is on
    Your machine doesn't have a Absolute manual switch but you can go to OPR page to turn it off

    Ahn Vuong

  7. #7
    Join Date
    Sep 2008
    Posts
    12

    SUCCESS

    Thanks for the help.
    It was the switch on the OPR page set wrong. THink it was the apprentice pressing buttons again!!

    Once again thanks

    ian

Similar Threads

  1. Absolute minimum machine spec for EMC2 latest build?
    By irving2008 in forum LinuxCNC (formerly EMC2)
    Replies: 7
    Last Post: 07-24-2008, 12:30 PM
  2. machine reset parameter
    By priyo in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 11-28-2007, 07:45 AM
  3. Coord rotation and multiple coord systems
    By Shizzlemah in forum Fadal
    Replies: 2
    Last Post: 10-30-2007, 09:27 AM
  4. Absolute zero of the CNC Machine.
    By Evolution VIII in forum DIY CNC Router Table Machines
    Replies: 7
    Last Post: 06-17-2007, 05:43 AM
  5. BP Series II Interact IV spindle causing machine to reset.
    By ronmarkum in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 01-25-2006, 07:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •