585,670 active members*
4,397 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > Wanted: Feedback on Stepper control

Thread: Wanted: Feedback on Stepper control

Results 1 to 2 of 2
  1. 12-19-2004, 04:14 AM #1
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24220

    Wanted: Feedback on Stepper control

    Anybody have any experience, good or bad, with these products?
    http://imshome.com/
    Al
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
  2. 12-19-2004, 05:17 AM #2
    vladdy
    vladdy is offline Registered
    Join Date
    Feb 2004
    Posts
    361
    I've been running some of the IB463 drivers for a bit now, good for samller machines, need external reference for current adjust though..
    only support half / full step modes [this model],
    I'm thinking of macking an external current reference, with a low power hold mode while not rotating..
    Otherwise they are ok... do what I need them to..
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Stepper control software suggestions
    By jlawren6 in forum Uncategorised CAM Discussion
    Replies: 6
    Last Post: 05-21-2011, 11:42 AM
  2. Stepper Motor Control Basics
    By Halfnutz in forum Stepper Motors / Drives
    Replies: 12
    Last Post: 05-24-2005, 07:40 PM
  3. Have existing stepper motors but want to replace control board with integral drivers.
    By Gerald_D in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 05-22-2005, 03:55 PM
  4. MicroProto Micromill Feedback Wanted
    By Jcadwell in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 02-11-2005, 09:06 AM
  5. Where to begin? Retrofit a Stepper Control to a Mill-Drill?
    By pfeist in forum Uncategorised MetalWorking Machines
    Replies: 9
    Last Post: 05-04-2004, 11:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules