Hello All,

What a great forum and what a vast of information available.

I have searched the forum but can't seem to find any suggestions, so here goes.

I have recenlty purchased solsylva plans in order to have a crack at creating my own cnc router.

What i am really stuck on is, which kit should i buy, a probotix, hobbycnc or xylotex. At first i will be producing a small 24x24 inch machine and will later move onto creating a 6 x 3 foot machine but want to keep the same electronics to transfer to new machine. From what i have gathered the probotix green monsters seem to be the strongest.

Even though they seem the strongest, will they be the slowest, or are they really the strongest, is there a better suggestion you guys recommend to a good allround setup?

I have read others suggesting to use bi-polar setups compare to unipolar but from what i have gathered all of hobbycnc drivers are unipolar.

So, what to do, which kit to buy and what is everyone else out there using, planning to run the setup with MACH 3 software.

Thanks in advance.