Originally Posted by
j44snk
Hi,
We have a 2006 Hyundai-Kia SKT-LMS lathe, one of the operators bumped it quite bad the other day.
The back corner of the tool turret (Cover over the live tooling belt) hit the sub spindle so hard it split the casting,
I have repaired this but it has alarmed out with a torque error whilst rapiding, it did't hit anything, just stopped in the middle of a move?????
Also it did a .300" cut with the finishing tool on 1 job, previous job & next job did.01"???? operator swears he didn't change anything in between & the m/c must of lost it's position.
I have re-aliged this machine, & yes I have done it correctly.
This m/c was never a well built m/c but now it's totally unpredictable.
My question is on the position page, page >, MONI, our X-axis load is at 45-50% if we wind X+ or 35% if we wind X-.
If anyone else has this machine, is this normal??????
We also have a Okuma L-470 box way & the x-axis is at 9%!!!!!!
I don't know what it was before the bump & suspect the ball screw may of been damaged :-(
Jason