[MarshCustom]

I have a Fryer mb-15 cnc mill. It has an auto way oiler that puts out too much oil. I go through more than a litre of way oil a week. I would like to slow it down because it makes my coolant nasty and spoils faster. On the bridgeport you can turn a knob to increase or decrease the amount of oil needed. The fryer has directions but appear to be in Chinese. It also has Anilam 3000 control. I was thinking that it might have a code in it to slow it down. Thanks

[diyengineer]

Is it a pneumatic or electric oiler? If its pneumatic, just crank down the input pressure and i bet that would work. Might have to install a regulator to it. If its electric, specifically DC you could use a inline speed controller to the motor to slow it down, Not sure if you could do the same with a AC motor or not, someone else would have to pipe in.