[Dolphin USA]

We have added a few actual machining videos to the site. We plan to add many more over time. See what you think.

The link is http://www.dolphincadcamusa.com/inde...id=17&Itemid=6

[Dolphin USA]

Just to add further to this. If anyone has any videos that they have created, we are always interested in adding more. Send them to [email protected] to be looked at.

Thank you.

[harley4ever]

Sent.

[harley4ever]

The videos on the site are a very good idea BUT, I dont think they should be under the tutorials section. The videos arent actually a tutorial. Maybe rename the page and put the actual tutorials under the tutorials page.

Just my 2 cents

[Dolphin USA]

Hi Harley,

Thank you for the input. We have made a change. For now, the tutorials are on our site on pretty much every page (either on the right hand or left hand side). We have roughly 50-60 tutorials overall that we will be adding to a dedicated "Tutorials" page shortly. The page that the machining videos were on was named "Tutorials", we have changed that to "Machining Videos".
Visit www.dolphincadcamusa.com to see the changes.

P.S. Feedback is always very much appreciated.

[Dolphin USA]

Another new simple drilling video added to the "Machining Videos" section.