I have a loop program with 6 locations (one for each work offset) and it is in HNC (Hurco basic). I sell a manual (intro and advanced total of $70.00 USD). All you have to do is paste your program in and put an M99 on the end of it and POOF it runs! I use it every week no bugs. I cut graphite electrodes and multiple cores and cavities on injection mold tooling. I could modify it to run NC if needed. Let me know if I can help.
Jetski (alias Tooling and Engineering Czar)
"I may not have the keys to success.. but I have learned to pick the locks"