585,737 active members*
4,926 visitors online*
Register for free
Login

Thread: CNC Driver Board Suggestions

Results 1 to 2 of 2
  1. 03-19-2009, 04:58 AM #1
    greg3000
    greg3000 is offline Registered
    Join Date
    Dec 2007
    Posts
    4

    CNC Driver Board Suggestions

    Can anyone tell me where I can find a good CNC driver board? I purchased a kit but it did not have a CNC driver board included. It did have 3 NEMA 23 stepper motors (4 wire, 113 oz inch).

    Regards,
    Gre
    Reply With Quote Reply With Quote
  2. 03-19-2009, 05:53 AM #2
    port_huon
    port_huon is offline Registered
    Send a message via Yahoo to port_huon
    Join Date
    Dec 2007
    Posts
    362
    It's hard to go past Geckos. All depends on requirements/budget.
    Regards
    Geoff
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Backer board and pressure/vac foot suggestions?
    By ecotectoo in forum MetalWork Discussion
    Replies: 0
    Last Post: 06-17-2008, 11:39 PM
  2. driver board suggestions
    By pjpj410 in forum Stepper Motors / Drives
    Replies: 4
    Last Post: 03-31-2008, 09:48 PM
  3. breakout board suggestions for mach and lathe
    By panaceabea in forum Mach Lathe
    Replies: 4
    Last Post: 12-15-2007, 10:20 PM
  4. single axis driver and a b.o.b.,or multi-axis driver board
    By .xXACEXx. in forum Stepper Motors / Drives
    Replies: 3
    Last Post: 07-03-2007, 05:13 AM
  5. driver board
    By mtaddei in forum Benchtop Machines
    Replies: 1
    Last Post: 11-19-2004, 09:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules