[Khalid]

Here is the 3D Bear I did couple of weeks ago..

1- used 6.5mm Endmill for rough passess ( the relief height was 14mm)
2- Used 3mm ball nose cutter for finish pass
3- Used 3mm ball nose for profile cut..

Thanks for watching

[Khalid]

Here is the finished form

[Northboy]

Nice work again Khalid!

You are one of my main inspirations for finally getting at building my own machine.


Northboy

[harryn]

Hi Khalid,

Nice work as usual.

I am sure you posted it somewhere, but could you please again explain how you hold your parts while they are being machined ?

I see the screws which hold the corners of the work down, but I am less clear how you hold down pieces like your fish. In that case, you were routing out the inside of the wood so when it is released - what keeps it from going flying ?

Thanks

HarryN

[hainjulia]

Wow those looks great Khalid...Really you done a great job ...Keep up the good work ...Thanks for sharing with us ...

jewellers

[Khalid]

Thanks all of you for liking..

Harry i used two sided tape for the fish case...

[CarveOne]

Very nice project once again Khalid. I just marvel at how you can get so much CNC work done.

CarveOne