I have some connectors I wanted to use. They are 4 pin so I was wondering if I could use the com from motor to case ground and then to com on controller.
Thanks Ed
Results 1 to 1 of 1
-
03-27-2009, 04:21 AM #1
Registered
- Join Date
- Feb 2006
- Posts
- 174
motor com and case ground pro board
Reply With QuoteSimilar Threads
-
Frame ground vs. Electrical ground.
By polaraligned in forum CNC (Mill / Lathe) Control Software (NC)Replies: 2Last Post: 11-24-2008, 11:21 PM -
grounding question, PC case ground
By Fiero Addiction in forum Waterjet General TopicsReplies: 2Last Post: 08-16-2008, 01:40 PM -
To Ground or not to Ground That is the question!
By Mr.Chips in forum DIY CNC Router Table MachinesReplies: 1Last Post: 03-16-2008, 09:10 PM -
Motor Driver where to put ground?
By Trapper14 in forum CNC Machine Related ElectronicsReplies: 10Last Post: 08-08-2006, 08:20 AM -
Motor supply ground vs Logic ground?
By Gashmore in forum CNC Machine Related ElectronicsReplies: 11Last Post: 06-07-2005, 11:21 PM
Posting Permissions
