Is there a way to change the tracking point in this case the right side instead of the left side of a grooving tool doing the cutting, when using the lathe point toolpath?
Thread: lathe point toolpath
Results 1 to 1 of 1
-
04-12-2009, 11:57 PM #1
Registered
- Join Date
- Nov 2005
- Posts
- 244
lathe point toolpath
Reply With QuoteSimilar Threads
-
using 4th axis toolpath posts out point to point on A axis?
By tnik in forum SurfcamReplies: 2Last Post: 02-07-2009, 12:59 AM -
point cloud to toolpath
By adamchapman in forum MastercamReplies: 21Last Post: 11-23-2008, 08:37 AM -
VM5 Toolpath starting point
By Prboz in forum Visual MillReplies: 1Last Post: 11-06-2008, 11:07 PM -
change at point toolpath option
By PETE1968 in forum MastercamReplies: 0Last Post: 07-06-2007, 05:50 PM -
2D Toolpath Start Point?
By mlinder in forum OneCNCReplies: 14Last Post: 09-07-2003, 05:28 PM
Posting Permissions
