Is this safe to use? I noticed feed rates went through the roof where minimal material is being removed.
Is this worth digging into. I am just wondering what success/failure stories others have had using it. Tips appreciated. I am a bit afraid of using it since it looks like it may cause some unpredictable results.
Thanks.
Results 1 to 2 of 2
-
05-02-2009, 10:19 PM #1
Registered
- Join Date
- May 2007
- Posts
- 327
run HighFeed optimization on toolpath - tips please.
-
05-07-2009, 05:13 AM #2
Moderator
- Join Date
- Jan 2006
- Posts
- 4396
Do a little Googling for HSM or High Speed Machining.
http://www.google.com/webhp?hl=en#hl...fp=9nKAxhopn7MToby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Reply With Quote
Similar Threads
-
highfeed machining
By SHKROHN in forum MastercamReplies: 1Last Post: 07-11-2008, 07:56 PM -
highfeed
By camtd in forum MastercamReplies: 0Last Post: 07-04-2007, 11:48 AM -
anybody compare HT finecut tips to TD 1Torch tips for dross?
By Knut in forum Waterjet General TopicsReplies: 0Last Post: 09-29-2006, 07:17 PM -
Optimization?????
By sdeering in forum Mach Software (ArtSoft software)Replies: 15Last Post: 01-27-2006, 11:58 PM -
Drafts: Tips for vendors and tips for RFQ writers...
By InspirationTool in forum Employment OpportunityReplies: 3Last Post: 12-21-2005, 03:44 AM
Posting Permissions
