We are new to the cnc world and have a ShopSabre 36x36 router. One of the things we have encountered is that it is difficult to align the x,y and z to the work from the keyboard. As a result we work with two guys. A friend of ours is a machinist and recommended a hand held remote for operation.
Do you know of a remote that works with the WinCNC software and if so where can I get one?
Thanks,
Mike Westvang
Dryad Bows Inc.
Thread: cnc hand held remote
Results 1 to 2 of 2
-
05-10-2009, 03:57 PM #1
Registered
- Join Date
- May 2009
- Posts
- 28
cnc hand held remote
-
05-10-2009, 05:40 PM #2
Registered
- Join Date
- Jun 2007
- Posts
- 268
My dynatorch has a joystick option, i have the joy stick but havent used it...
My key board is wirerless so if i need to line up on something i take it over to the table. Not sure what the range is on the keyboard, i only go about 8 feet away from the computer and it works fine.
EDD
Reply With QuoteSimilar Threads
-
Hand held digital tachometer recommendation
By Ken_Shea in forum Community Club HouseReplies: 6Last Post: 10-05-2007, 02:43 PM -
Hypertherm remote start with hand torch?
By Drad98 in forum Community Club HouseReplies: 0Last Post: 01-27-2007, 03:22 AM -
I need my hand held :D........Palm or HP??
By trubleshtr in forum Computers / Desktops / NetworkingReplies: 6Last Post: 01-14-2006, 01:58 AM -
coverting from Right-hand to left-hand coordinate system
By eltonr in forum Uncategorised CAM DiscussionReplies: 6Last Post: 10-15-2004, 02:40 AM -
Hand held band saw?
By njtermite in forum Hobby DiscussionReplies: 9Last Post: 03-08-2004, 04:50 AM
Posting Permissions
